Acoustic Slat Wall Panels Installation Instructions 

Tools and Materials Needed:

• Acoustic Slat Wall Panels

• Level

• Measuring Tape

• Silicone Glue (preferred), Liquid Nails, or Nails

• Table Saw, Electric Saw, Hand Saw, or Box Cutter (for cutting panels)

• Stick or Spreader (for evenly applying adhesive)

• Double Adhesive Tape (optional, for temporary fixing)

• Safety Gloves

Step 1: Prepare the Wall

1. Clear the Area: Remove any furniture and decorations from the wall.

2. Inspect the Wall: Ensure it’s clean, dry, and free of defects. Patch any holes or imperfections.

Step 2: Measure and Cut Panels

1. Measure Wall Area: Measure the height and width of the wall.

2. Cut Panels to Size: Use a table saw, electric saw, hand saw, or box cutter to cut the panels to fit the wall. Sand any rough edges if needed.

Step 3: Plan the Layout

1. Dry Fit Panels: Lay out the panels on the floor to visualize their arrangement.

2. Mark Starting Point: Choose a starting point (usually a corner) and mark it on the wall.

Step 4: Install Panels

1. Apply Adhesive: Use a stick or spreader to evenly apply silicone glue (preferred), liquid nails, or nails on the back of the panel in a zigzag pattern.

2. Position the Panel: Align the panel with your marked starting point and check it with a level to ensure it’s straight. Press it firmly against the wall.

3. Use Temporary Fixing (Optional): If desired, use double adhesive tape to hold the panel in place while the adhesive cures. This is not necessary but can provide additional support.

4. Continue Installing Panels: Repeat the process for each panel, ensuring they fit snugly together.

Step 5: Finishing Touches

1. Clean Up: Wipe away any excess adhesive and debris from the installation area.

Step 6: Allow to Set

1. Curing Time: Allow the adhesive to cure for the recommended time (usually 24 hours) before using the space.

Safety Tips

• Always wear safety gloves when cutting and handling panels.

• Ensure good ventilation when using silicone glue or liquid nails.